Scraping Pegs - Revision history

Bokonon at 21:16, 19 August 2009

2009-08-19T21:16:22Z

← Older revision		Revision as of 17:16, 19 August 2009
Line 1:		Line 1:
	[[Category:New Riders]]		[[Category:New Riders]]
	[[Category:Riding Techniques]]		[[Category:Riding Techniques]]
	~~You really have~~ to ~~have faith in the bike,~~ that it ~~will stay under you~~, ~~but it will~~, ~~as long as~~ you ~~have the correct tire pressure and~~ are ~~on dry~~, ~~clean pavement~~.		The footpeg feelers are there for a reason, and that's to tell you that you're about to lean over too far. If you're consistently scraping them it may be time to improve your riding technique, suspension, or both.

	Try making circles in an empty parking lot at about 10-15 ~~MPH~~. Keep making the circle tighter to gain confidence - and eventually it won't go over any further...scraaaape.		It is the general opinion of this board that if you are scraping pegs while street riding, either your technique needs improvement or you're going too fast. Or both.

			To practice: Try making circles in an empty parking lot at about 10-15 mph. Keep making the circle tighter to gain confidence - and eventually it won't go over any further...scraaaape.

	It's not a good idea to go much further than that, as the centerstand, sidestand mount plate or exhaust pipe will drag at really high lean angles, and can lever the rear tire right off of the ground; introducing the words "~~low~~ side" and "road rash" into your vocabulary ~~(avoid this).~~		It's not a good idea to go much further than that, as the centerstand, sidestand mount plate or exhaust pipe will drag at really high lean angles and can lever the rear tire right off of the ground, introducing the words [[Biker Speak\|"high side"]] and "road rash" into your vocabulary.

	~~It is the general opinion of this board that if you are scraping pegs while street riding, either your technique needs improvement or you're going too fast~~.

	~~Or both~~.		You really have to have faith that the bike will stay under you, but it will, as long as you have the correct tire pressure and are on dry, clean pavement. Go over too far, though, and things will happen fast.

Bokonon at 06:31, 8 April 2007

2007-04-08T06:31:21Z

← Older revision		Revision as of 02:31, 8 April 2007
Line 1:		Line 1:
	[[Category:New Riders]]		[[Category:New Riders]]
			[[Category:Riding Techniques]]
	You really have to have faith in the bike, that it will stay under you, but it will, as long as you have the correct tire pressure and are on dry, clean pavement.		You really have to have faith in the bike, that it will stay under you, but it will, as long as you have the correct tire pressure and are on dry, clean pavement.

Bokonon at 13:59, 4 June 2006

2006-06-04T13:59:27Z

New page

[[Category:New Riders]]
You really have to have faith in the bike, that it will stay under you, but it will, as long as you have the correct tire pressure and are on dry, clean pavement.

Try making circles in an empty parking lot at about 10-15 MPH. Keep making the circle tighter to gain confidence - and eventually it won't go over any further...scraaaape.

It's not a good idea to go much further than that, as the centerstand, sidestand mount plate or exhaust pipe will drag at really high lean angles, and can lever the rear tire right off of the ground; introducing the words "low side" and "road rash" into your vocabulary (avoid this).

It is the general opinion of this board that if you are scraping pegs while street riding, either your technique needs improvement or you're going too fast.

Or both.