Ninja 250 Carburetor Needle Information: Difference between revisions
| (One intermediate revision by the same user not shown) | |||
| Line 43: | Line 43: | ||
Reprofiling a stock needle is a job for a machinist, and is beyond the | Reprofiling a stock needle is a job for a machinist, and is beyond the | ||
capabilities of most Ninja 250 owners. | capabilities of most Ninja 250 owners. | ||
The Ninja 250's stock carburetor is a Keihin CVK30. | |||
The stock needle is marked N16I at the top, and is Kawasaki part number 16009-1461. It's made of brass. | The stock needle is marked N16I at the top, and is Kawasaki part number 16009-1461. It's made of brass. | ||
| Line 156: | Line 158: | ||
[[File:jetneedle-horiz.jpg|right]] | [[File:jetneedle-horiz.jpg|right]] | ||
BrianM submitted this information about an aftermarket jet needle. He was unsure which needle it was, but as the measurements don't match those of the Factory Pro needle above, it's | BrianM submitted this information about an aftermarket jet needle. He was unsure which needle it was, but as the measurements don't match those of the Factory Pro needle above, it's likely that this is the DynoJet needle. | ||
<table border=0> | <table border=0> | ||