My LED turn signals don't work right: Difference between revisions
| Line 53: | Line 53: | ||
At the six-connection plug under the headlight, use a paper clip to remove the green and grey wires from the male side of the plug. These are the two wires that run from the turn signal switch out to the signal themselves. You are going to splice into these wires, so leave enough wire on both ends, ie... make your cut several inches back from the connector. | At the six-connection plug under the headlight, use a paper clip to remove the green and grey wires from the male side of the plug. These are the two wires that run from the turn signal switch out to the signal themselves. You are going to splice into these wires, so leave enough wire on both ends, ie... make your cut several inches back from the connector. | ||
[[Soldering 101|Solder]] the anode (+) end of the diodes individually, one to the green and one to the grey wire. Then you need to solder the cathode (-) end of both diodes together to the grey wire. This is going to be the ground. | [[Soldering 101|Solder]] the anode (+) end of the diodes individually to the part of the wire that is still on the harness, one to the green and one to the grey wire. Then you need to solder the cathode (-) end of both diodes together to the grey wire with a connector that you cut off. This is going to be the ground. | ||
[[image:1SixPlugConn-REV1.jpg|150px]] | [[image:1SixPlugConn-REV1.jpg|150px]] | ||