Scraping Pegs

From Ninja250Wiki
Revision as of 09:59, 4 June 2006 by Bokonon (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

You really have to have faith in the bike, that it will stay under you, but it will, as long as you have the correct tire pressure and are on dry, clean pavement.

Try making circles in an empty parking lot at about 10-15 MPH. Keep making the circle tighter to gain confidence - and eventually it won't go over any further...scraaaape.

It's not a good idea to go much further than that, as the centerstand, sidestand mount plate or exhaust pipe will drag at really high lean angles, and can lever the rear tire right off of the ground; introducing the words "low side" and "road rash" into your vocabulary (avoid this).

It is the general opinion of this board that if you are scraping pegs while street riding, either your technique needs improvement or you're going too fast.

Or both.